Features
- Audio probing and cable tracing function
- Check wiring error in 5E, 6E, coaxial cable such as open circuit, short circuit, jumper wire, reverse connection or cross-talk interference
- Locate the wiring or connection error
- Measure cable length and determine the distance of open circuit and short circuit
- Dynamically calibrate cable length and make length measurement as accurate as 97%
- Directly find the RJ45 cable
- In search for other metal cable
- Measuring network line-break
- Measure twisted-pair length
- Auto power off function
- Simple and easy use. Big LCD screen to display test result clear
- Portable unit with long battery life (standby 50 hours)
- Automatically time-delay shut off
- Measure length and pair with or without the far-end recognizer
- Locate cable and there are 8 far-end passive (remote identifier) test jacks [1D1-ID8]
(Note: only 1 ID1 is included on set ) - Far-end recognizer (remote identification) with prompting voice
- Self-checking function
- Automatically compensate any change in battery capacity or ambient temperature
- Single board computer software watchdog design with reliable operation
Specifications:
- Display: Special 4 x 16 character big screen LCD lattice(valid visual field 61.6 x 25.2mm)
- Type of Cable Tested
- STP/UTP twin twisted cable
- Coaxial cable (RJ45-to-BNC converter is not included in the set)
- Type of cable detected
- 5E & 6E
- Coaxial cable (RJ45-to-BNC converter is not included in the set)
- Other metal wires
- Tester Port
- Tester RJ45 master port (L), tester LOOPBACK RJ45 port (R)
- Length Measurement of Twin Twisted Cable
- Scope: 1~350M ( 3 ~ 200ft)
- Calibration accuracy: 3% (±0.5M or ±1.5ft) (calibrating cable > 5M)
- Shipment accuracy: 5% (±0.5 M or ±1.5 ft) (AMP, AT&T Class 5 cable)
- Display: M (meter) or ft. (feet)
- Length Calibration
- User can set calibration factor by himself with a given length cable
- Length of calibrating cable is more than 5M
- Wire Sequence and Locating Cable Error: Check errors such as
- Open circuit
- Short circuit
- Reverse connection
- Cross-over or cross-talk interference
- Locating Cable: 8 Remote identifier test jacks (ID1 to ID8) (Note: only one ID1 is included on set)
- Automatic Time-delay Shut Off Time: if idle for 30 minutes
- Power Supply
- Main Unit: 4 x 1.5V AA batteries (not included in set)
- Receiver: 1 x 9V battery (included)
- Overall dimension
- Main tester: 180 x 80 x 40mm
- Receiver: 218 x 46 x 29mm
- Remote Identifier: 77 x 31 x 21mm