Get the most out of your home audio system by ensuring the best connection from your speaker cable to your receiver with Deadbolt Banana plugs. The self-crimping teeth on these plugs provides a simple, secure, and low-profile connection without requiring soldering or screws.
How to Install Deadbolt Banana Plugs- Unscrew the cap off the Deadbolt Banana Plug.
- Feed the bare conductor of the speaker wire through the center hole of the banana plug. (strip wire about 1/2")
- Bend the wires of the speaker wire down around the teeth.
- Replace the cap to secure the speaker wire.
- Your Deadbolt Banana Plug is ready for connection.
Banana plugs offer an alternative to inserting a bare speaker wire into the equipment. Often a bare speaker connection is not as reliable as a guaranteed banana plug connection. Wires tend to get pulled out or frizzy after time passes. Banana plugs require only one install, giving you a permanent and robust connector at the end of your speaker wire.
Premium Materials- 24k Gold Plating on Connector and Crimping Teeth
- Pure, High Density Copper Connector
- Heavy Duty Brass (black) Casing
- 4mm Tip
- 24k Gold Plating on Connector and Crimping Teeth
- Pure, High Density Copper Connector
- Heavy Duty Brass (black) Casing
- Maximum accepted AWG: 8 AWG (10 AWG suggested)
- Maximum Jacket AWG: 2 AWG~ (1/4")
- Will need to strip about 1/2" of the jacket off the end of your speaker wire to terminate
- Total Length: 1.7in (43.3mm)
- Plug Length 0.67in (17mm)
- Plug diameter: 0.13-0.18in (3.4-4.7mm)
- Outside Diameter (sleeve): 0.51in (13mm)
- Inside Diameter (sleve): 0.25in (6.4mm)
- Sleeve length: .73in (18.6mm)
- Outside Diameter (connector): 0.45in (11.4mm)
- Inside Diameter (connector): 0.28in (7.25mm)
- Connector depth 0.55in (14mm)